Abstract
The development of active and stable earth-abundant catalysts for the oxygen reduction reaction (ORR) is needed for widespread, economic development of fuel cell technologies. Designing and optimizing these non-platinum group metals is challenging, however, because they are susceptible to composition and structure changes, including dissolution, oxidation, and corrosion, both in air and under reaction conditions. To identify the active surface, and thus understand the properties that affect activity, the catalyst surface must be characterized in situ. Herein, we utilize a grazing incidence electrochemical cell to investigate in situ composition and morphology changes of a molybdenum nitride (Mo-N) thin film catalyst using grazing incidence x-ray absorption spectroscopy (GI-XAS) and x-ray reflectivity (XRR). In rotating ring disk electrode measurements, we find that the activity, selectivity, stability, and capacitance of the Mo-N catalyst is dependent on the maximum potential to which it has been exposed. Specifically, the overpotential required to reach -2 mA cm-2geo decreases by over 90 mV when the maximum potential is increased from 0.3 to 0.8 V vs RHE (Figure 1). Because the Mo-N oxidizes rapidly in air, ex situ characterization methods including x-ray photoelectron spectroscopy and time-of-flight secondary ion mass spectrometry can provide only limited insight into these in situ catalyst changes. Using in situ GI-XAS measurements at applied potentials between 0.3 and 0.9 V vs RHE, however, we are able to determine that the surface of the film oxidizes and becomes more amorphous when exposed to increasingly higher potentials (Figure 1). Furthermore, the surface remains oxidized on the order of several hours when returned to "ORR relevant potentials" (< 0.6 V vs RHE), indicating that this surface-oxidized nitride is the active surface for ORR. Using in situ XRR measurements, we find that there is no change in surface roughness at potentials below 0.7 V vs RHE, but the film roughens significantly at 0.8 V vs RHE, correlating with ex situ measurements of Mo dissolution at this potential (Figure 1). We therefore conclude that the intrinsic activity of the Mo-N catalyst increases when exposed to potentials up to 0.7 V vs RHE, while above that potential activity enhancements are due to the exposure of more active sites through dissolution. The in situ electrochemical surface-sensitive x-ray characterization as used here is a promising methodology for understanding and leveraging surface dynamics to improve the performance of non-traditional catalysts.
