Skip to main content
SHARE
Publication

Particle Generation by Ultraviolet-Laser Ablation during Surface Decontamination...

by Meng-dawn Cheng
Publication Type
Journal
Journal Name
Journal of the Air & Waste Management Association
Publication Date
Page Numbers
1591 to 1598
Volume
56
Issue
11

A novel photonic decontamination method was developed by removal of pollutants from material surfaces. Such a method relies on the ability of a high-energy laser beam to ablate materials from a contaminated surface layer, thus producing airborne particles. In this paper, the authors presented the results obtained using a scanning mobility particle sizer (SMPS) system and an aerosol particle sizer (APS). Particles generated by laser ablation from the surfaces of cement, chromium-embedded cement, and alumina were experimentally investigated. Broad particle distributions from nanometer to micrometer in size were measured. For stainless steel, virtually no particle >500 nm in aerodynamic size was detected. The generated particle number concentrations of all three of the materials were increased as the 266-nm laser fluence (milijoules per square centimeter) increased. Among the three materals tested, cement was found to be the most favorable for particle removal, alumina next, and stainless steel the least. Chromium (dropped in cement) showed almost no effects on particle production. For all of the materials tested except for stainless steel, bimodal size distributions were observed; a smaller mode peaked at ~50-70 nm was detected by SMPS and a larger mode (peaked at ~0.70-0.85�m) by APS. Based on transmission electron microscopy observations, the authors concluded that particles in the range of 50-70 nm were aggregates of primary particles, and those of size larger than a few hundred nanometers were produced by different mechanisms, for example, massive object ejection from the material surfaces.