Abstract
This paper describes the ramp up of the beam power for the Spallation Neutron Source by ramping up the pulse length, the repetition rate, and the beam current emerging from the H- source. Starting out with low rep rates (<10 Hz) and short pulse lengths (<<0.3 ms) the H- source and LEBT delivered from LBNL exceeded the requirements with almost perfect availability. This paper discusses the modifications that were required to exceed 0.2 ms pulse length and 0.2% duty factor with acceptable availability and performance. Currently the source is supporting neutron production at 1 MW with 38 mA LINAC beam current at 60 Hz and 0.9 ms pulse length. The pulse length will be increased to ~1.1 ms to meet the requirements for neutron production with a power between 1 and 1.4 MW. A MEBT beam current of 46 mA with a 5.4% duty factor has been demonstrated for 32 hours. A 56mA MEBT beam current with a 4.1% duty factor has been demonstrated for 20 minutes at the conclusion of a 12 day production run. This is close to the 59 mA needed for 3 MW neutron productions. Also notable is the Cs2CrO4 cesium system, which dispenses ~10 mg of Cs during the startup of the ion source, sufficient for producing the required 38 mA for 4 weeks without significant degradation.
