News

In this artist’s conception of the process, an automated deposition system places a new material onto a base material (purple beam, right) as the last sample that was made is analyzed and sent to the AI (green beams, brain, left). The AI tells the pulsed laser deposition machine what to do next (data cable, bottom).
Researchers harness AI for autonomous discovery and optimization of materials
Students gather at a poster session
Students acquire skills at Quantum Science Center
Rectangular box being lifted by a red pully system up the left side of the building
Researchers make ‘green’ floor to replace steel

Filter News

Area of Research

News Type

Date

News Topics

Media Contacts

Connect with ORNL

ORNL used novel additive manufacturing techniques to 3D print channel fasteners for Framatome’s boiling water reactor fuel assembly. Four components, like the one shown here, were installed at the TVA Browns Ferry nuclear plant. Credit: Framatome

Nuclear reactor components 3D printed by ORNL now installed at TVA Browns Ferry nuclear plant

Four first-of-a-kind 3D-printed fuel assembly brackets, produced at the Department of Energy’s Manufacturing Demonstration Facility at Oak Ridge National Laboratory, have been installed and are now under routine operating

The REVISE-II modeling tool developed at ORNL supports decision-making for electric vehicle charging infrastructure development along interstate highways in support of intercity travel. Credit: Jason Richards/ORNL, U.S. Dept. of Energy

Electric vehicles – Charged-up planning

Researchers at Oak Ridge National Laboratory have developed a nationwide modeling tool to help infrastructure planners decide where and when to locate electric vehicle charging stations along interstate highways. The goal is to encourage the adoption of EVs for cross-country travel.

An X-ray CT image of a 3D-printed metal turbine blade was reconstructed using ORNL’s neural network and advanced algorithms. Credit: Amir Ziabari/ORNL, U.S. Dept. of Energy

Manufacturing – Defect detection

Algorithms developed at Oak Ridge National Laboratory can greatly enhance X-ray computed tomography images of 3D-printed metal parts, resulting in more accurate, faster scans.