News

In this artist’s conception of the process, an automated deposition system places a new material onto a base material (purple beam, right) as the last sample that was made is analyzed and sent to the AI (green beams, brain, left). The AI tells the pulsed laser deposition machine what to do next (data cable, bottom).
Researchers harness AI for autonomous discovery and optimization of materials
Students gather at a poster session
Students acquire skills at Quantum Science Center
Rectangular box being lifted by a red pully system up the left side of the building
Researchers make ‘green’ floor to replace steel

Filter News

Area of Research

News Type

Date

News Topics

Media Contacts

Connect with ORNL

An illustration shows how the composite is pressed into a seamless aluminum liner, which is then sealed with an aluminum powder cap. The research is sponsored by the DOE Isotope Program. Credit: Chris Orosco/ORNL, U.S. Dept. of Energy

Faster, safer target prep

Oak Ridge National Laboratory researchers have developed a method to simplify one step of radioisotope production — and it’s faster and safer.

Using as much as 50 percent lignin by weight, a new composite material created at ORNL is well suited for use in 3D printing.

New composite advances lignin as a renewable 3D printing material

Scientists at the Department of Energy’s Oak Ridge National Laboratory have created a recipe for a renewable 3D printing feedstock that could spur a profitable new use for an intractable biorefinery byproduct: lignin.